Skip to content

Automatic Matching of Bullet Land Impressions

Journal: The Annals of Applied Statistics
Published: 2017
Primary Author: Eric Hare
Secondary Authors: Heike Hofmann, Alicia L. Carriquiry
Research Area: Firearms and Toolmarks

In 2009, the National Academy of Sciences published a report questioning the scientific validity of many forensic methods including firearm examination. Firearm examination is a forensic tool used to help the court determine whether two bullets were fired from the same gun barrel. During the firing process, rifling, manufacturing defects, and impurities in the barrel create striation marks on the bullet. Identifying these striation markings in an attempt to match two bullets is one of the primary goals of firearm examination. We propose an automated framework for the analysis of the 3D surface measurements of bullet land impressions, which transcribes the individual characteristics into a set of features that quantify their similarities. This makes identification of matches easier and allows for a quantification of both matches and matchability of barrels. The automatic matching routine we propose manages to (a) correctly identify land impressions (the surface between two bullet groove impressions) with too much damage to be suitable for comparison, and (b) correctly identify all 10,384 land-to-land matches of the James Hamby study (Hamby, Brundage and Thorpe [AFTE Journal 41 (2009) 99–110]).

Related Resources

Advancing the Understanding of 3D Imaging for Firearms Identification

Advancing the Understanding of 3D Imaging for Firearms Identification

Houston Forensic Science Center, in collaboration with CSAFE, has been awarded an NIJ grant to conduct a study focused on comparability of images acquired by 3D instruments manufactured by different…
Algorithmic matching of striated tool marks

Algorithmic matching of striated tool marks

Automatic matching algorithms for assessing the similarity between striation marks have been investigated for bullet lands and some tool marks, such as screwdrivers. We are interested in the investigation of…
A reproducible pipeline for extracting representative signals from wire cuts

A reproducible pipeline for extracting representative signals from wire cuts

We propose a reproducible pipeline for extracting representative signals from 2D topographic scans of the tips of cut wires. The process fully addresses many potential problems in the quality of…
An algorithm for forensic toolmark comparisons

An algorithm for forensic toolmark comparisons

Forensic toolmark analysis traditionally relies on subjective human judgment, leading to inconsistencies and lack of transparency. The multitude of variables, including angles and directions of mark generation, further complicates comparisons.…